Standard Installation Information for TV and Internet via satellite

STANDARD PROFESSIONAL INSTALLATION OF A SATELLITE INTERNET SYSTEM and or SATELLITE TV SYSTEM

The satellite system equipment, unless already received by customer.

 Mount Dish or Minidish (antenna) to side of house or 1st story roof mount.
*Note: Pole mount is NOT part of standard install. (see below)

 Running 2 RG-6 cables (not to exceed 150 feet) around the outside of the house to an exterior / interior wall entry point. (This does not include attic or crawlspace work)

 Installation of proper wall cover for cable , two RG-6 cable to Satellite Receiver (WildBlue) and a cat5 network cable to connect your computer system to the WildBlue Satellite Internet System.

 Grounding of system to a suitable ground location.

 Please discuss any non-standard requirements with us over the phone and again when the installer arrives on site. Although your home may be unique in some fashion that will not accommodate a standard installation, the installer will discuss these additional charges with you before the install begins.

The list below identifies items that are not included in a standard installation. Most installers charge extra for these items. Do not allow any work to be done until you and your installer clearly understand and approve the additional work and its additional cost. SUPERVISE all work performed by your installer.
If you have any questions, please call us at 1-502-222-6003

STANDARD PROFESSIONAL INSTALLATION OF A SATELLITE INTERNET SYSTEM DOES NOT INCLUDE THE FOLLOWING

 Relocation of any TV receiver or moving of other satellite dish to accomplish work task.

 Removal and/or repair of previously mounted equipment without a Waiver of Liability signed off by customer.

 Extra RG-6 cable over 150 feet per run. Drilling through more than one exterior and one interior wall. Running cable through attics, basements, crawlspaces or walls.

 Phone jack wiring where existing service is more than 25 feet from the satellite TV receiver. (if applicable)
Providing any enhancements to existing phone system.

 Connections to stereo and/or various audio components other than a VCR co-located with the Dish Network receivers.

 Special moldings or other cosmetic hardware used to hide exposed cables.

 Non-penetrating roof mount, pole mount* or chimney mount. 

 Mileage if customer is located outside of our service area.

 Complex and/or custom installations, including multiple DISH TV receivers, excess cabling requirements and wall fishes, etc., will result in additional fees.

 Mounting antenna higher than the first level roof.

 Networking multiple computers or connections to LANs.

 Please note that above installation methods applies to both WildBlue and Dish Network installations.

Share this post